MowerWatch › Guides
Written from real diagnostic casework — the same reasoning MowerWatch's diagnostics engine applies to your mower's own data.
Automower error E02 “No loop signal” — how to find the real causeE02 on a Husqvarna Automower means it can't hear the boundary loop. Where it happens matters more than how often: at the dock it's the station or power supply, in the lawn it's the wire.Automower keeps stopping with no error code — the STOP/hatch clueA Husqvarna Automower that stops dead with no error in the app is reporting a physical STOP input: the button or the hatch switch, not software.Automower charging keeps cutting out — contacts, power supply, or station?If your Husqvarna Automower flips between charging and ready every few seconds, or charges slower than ~1% a minute, work through contacts, power supply and station in that order.Automower won't leave the charging station — departure failures explainedA Husqvarna Automower that charges fine but errors the moment it tries to leave usually has a loop-signal problem at the station, not a broken wire in the lawn.Automower battery wear — cycles, shrinking runtime, and when to replaceHow to tell a worn Husqvarna Automower battery from other faults: charge cycle counts, runtime per charge, and what replacement involves.Automower blades — how often to replace and what dull blades doDull Husqvarna Automower blades tear grass instead of cutting it. Replacement interval, symptoms, and the five-minute job itself.Automower error E01 “Outside working area” — causes and fixesE01 means the Husqvarna Automower thinks it's on the wrong side of the boundary wire. Usually the wire, sometimes the signal, occasionally a slope or gap.